You are here:

Lightning protection


Go to to devices that are part of the capture system of an LPS:
- Active electronic lightning rods with Early Streamer Emission (ESE) devices, to NFC 17-102, CTE SU8, UNE 21186.
- Air terminals (Faradization - passive) to IEC 62305.
- Masts and anchorages.

Use Nimbus® Project to work out what lightning rod you should install.

Early streamer emission (ESE) lightning rods

Lightning rod with streaming device (ESE). Early streamer: 15, 30, 45 and 60 μs. NF C 17-102:2011, UNE 21186:2011 y CTE SU 8.

Air terminals

Franklin type lightning air terminal rods, AISI 316 stainless steel (with adapt. piece).

Adaptors


Masts and mast anchorages

A down conductor system should be composed of all the necessary components to discharge lightning energy to ground in a controlled and safe way.

Clamps


Cable brackets


Down conductors


Connecting sleeves


Protection pipe


Spark gaps

The grounding system is essential for the proper operation of the LPS and should be made up of all the components needed to dissipate lightning and surge currents.

Clamps


Earth electrodes


Ground connection and equipotentiality


Earth enhancing compounds

It is essential to properly maintain all lightning protection systems. In fact, certain components may lose their effectiveness over time due to corrosion, inclement weather, mechanical shock and lightning strikes. To satisfy the requirements of the standards, the mechanical and electrical characteristics of a lightning protection system must be maintained over its entire life.

Lightning discharge counters

Lightning discharge counters.

Maintenance testers

Devices that check the status of the early streamer emission circuit as well as the equivalent degree of protection of the lightning rod
Nimbus lightning rod tester for testing the early streamer emission internal circuit as well as the level of protection of the lightning rods.